oxlasers 15W High Power Blue Laser Module Fixed Focus Laser Head for DIY CNC Engraver Cut Plywood
[33029029706] Technical Parameters: Laser wavelength: 445nm-450nm blue laser Spot type: retangle spot (fixed focus, NOT FOCUSABLE) Size: 40*95mm(including fan and driverboard) Drive mode: external ACC constant current drive Cooling method: forced air cooling Operating voltage: 12V DC Control interface: 2 * 2.54 ( TTL/PWM 0-5V control power) Shell material: aluminum, surface anodized Collimator lens: optical glass coating THIS IS NOT A FOCUSABLE LASER, focus is fixed at the distance of 2CM from aperture this laser is for CNC laser engraving machine or laser cutter only, this laser can cut max 3-4mm plywood in speed of 150-200mm/MIN, and 1-2 passes!! PACKING LIST: LASER*1 2pin-2pin wires*2 DC-2Pin Connector*1 3pin-4pin cable*1 Focus Locating Column*1 SAFETY GLASSES*1 BUYER MUST READING: When you connect laser to your controller board, please pay attention to the pin positions of 12v+ GND- and PWM/TTL, red wire=12V+, black wire=GND-. Yello wire=PWM+, white wire=PWM-(3-4pin wire). So Red Wire must be connected to the 12v+ pin on your controller board’s interface, Black Wire Must be connected to the GND- pin and Yellow Wire must be connected to the PWM/TTL pin, White wire should be connected to the PWM- pin. if your controller board’s laser interface pins are in different position, please change the wires position to make it match the positions of + - PWM of your interface. If the wires connected wrong, it will damage the diode and the driver board. Please add a fan when you engraving or cutting, in case smoke blur the lens damage the lens
US $240.00Grab Now 40% US $144.00
Tidak ada komentar:
Posting Komentar